Questions tagged [tuning]

Optimization of a system by altering the mathematical parameters or coefficients of one or more of the system's models.

15 questions
Filter by
Sorted by
Tagged with
36 views

PID tuning - can't get stiffness without going unstable

I'm trying to tune a low-friction actuator. This actuator is controlled via a 24peak amp drive. I'm running into the problem where the system goes unstable prior to reaching good stiffness. I start ...
40 views

Real world dynamic problem suggestion for PID [closed]

I need you guys to suggest me a problem that requires to change PID coefficients in different times. Lets say every 1 minutes the environment should change and readjust the PID’s parameters. Note that ...
264 views

Problem with tuning PID for motor

I am trying to tune my PID to make my motor have a consistent output: input(pidOutput) => 100rpm I used the following step to tune my PID: Set all gains to zero. Increase the P gain until ...
1k views

PID Control: Integral error does not converge to zero

Good day, I had been recently reading up more on PID controllers and stumbled upon something called integral wind up. I am currently working on an autonomous quadcopter concentrating at the moment on ...
1k views

PID Tuning for an Unbalanced Quadcopter: When do I know if the I-gain I've set is too high?

Good day, I am working on an autonomous flight controller for a quadcopter ('X' configuration) using only angles as inputs for the setpoints used in a single loop PID controller running at 200Hz (PID ...
1k views

Tracking objects from camera; PID controlling; Parrot AR Drone 2

I am working on a project where I should perform object tracking using the camera of Parrot AR Drone 2.0. So the main idea is, a drone should be able to identify a specified colour and then follow it ...
298 views

P gain tuning for quadcopter (Is my perception for a P-gain too high correct?)

Good day, I am currently working on a project using Complementary filter for Sensor fusion and PID algorithm for motor control. I viewed a lot of videos in youtube as well as consulted various blogs ...
2k views

Tuning PD for line follower

I am trying to make line following robot. I am using atmega328p mcu, pololu 10:1 motors, pololu qtr6-rc sensor, 2s li-po. Here is my code: ...
109 views

Pole placement gains tuning

given my control system I have found the region of the complex space that satisfies my specifications, determining poles position in 0.5 +- 0.2i. Now I want to find the gains that fix the desider ...
131 views

In the PID equation K[((s+a)^2)/s] what values correspond to the PID coefficients Kp, Ki, Kd?

I'm trying to understand how to obtain the Kp, Ki, Kd values after finding a combination of K and a that works for me. Do I just expand the equation and take the coefficients?
2k views

How to tune the PID parameters using Fuzzy Logic?

I previously used the Ziegler method to tune the parameters of my PID controller to control my robot's position. I then implemented fuzzy logic for self-tuning the parameters. I have two inputs to ...
2k views

PID tuning method based on Pole placement

Is it possible to determine PID parameter using pole placement. I mean by solving the ch. eq. of close loop transfer functions which consists of either P,PI,PD or PID controllers?? Because i've ...
589 views

How can I optimise control parameters for a stepper motor?

As an industrial roboticist I spent most of my time working with robots and machines which used brushless DC motors or linear motors, so I have lots of experience tuning PID parameters for those ...