Linked Questions

2
votes
0answers
597 views

PID Control Tuning [duplicate]

Im currently designing a robot for my undergraduate project. One of the task of this robot is to follow the wall. For the purpose I'm using a PID control system, where the reference is given from a ...
4
votes
0answers
207 views

PID tuning to make my balancing robot better [duplicate]

See the video below of my balancing robot. Balancing robot I was having trouble getting it to balance on hard surfaces but finally got it after playing with the PID gains a lot. Previously it was ...
13
votes
3answers
18k views

Quadcopter PID tuning

In continuation of the question I asked here: Quadcopter instability with simple takeoff in autonomous mode ...I'd like to ask a few questions about implementing a basic PID for a quadrotor ...
9
votes
2answers
6k views

Line Follower optimization

I'm working on building a line follower robot and want to optimize its performance. It was suggested that I use a PID algorithm. I read a lot about PID but am confused a bit regarding following: I've ...
7
votes
2answers
3k views

Cascading PID DC Motor Position & Velocity Controllers

I'm trying to build a robot with a differential drive powered by two DC Motors. First I implemented a PID Controller to control the velocity of each motor independently. Estimated the TF using the ...
6
votes
4answers
2k views

PID control of tank-like robot and IMU

Consider a tank like robot with a motor driver channel for each side of the robot (two motors on the left and two motors on the right) and an IMU. I'm interested in driving the robot in a straight ...
0
votes
2answers
2k views

PID control against sine wave error

I'm writing a PID to control a toy car that follows a black line on a circuit. I've tuned my PID and it works at high speed for all the circuit except the winding section. For that, the error signal ...
4
votes
1answer
2k views

Grasshopper effect on a quadcopter with kk2.1.5

We have builded a quadcopter that use the flight manager kk2.1.5 with the latest firmware. When we increase the throttle, it flight. When we keep the hand on the stick we are able to maintain it but ...
2
votes
1answer
1k views

Line follower PID tuning for high speed

I have a line following differential drive robot with a PID control. I successfully tuned (try and error) the P,I,D constants for a good stability in low speeds, but when I increase the speed, ...
2
votes
1answer
618 views

Python PID tuning - Parrot Bebop 2 - Target follower - ROS

I'm developing a PID controller for making the drone follow a detected object. I used as reference these topics: Ttracking-objects-from-camera-pid-controlling-parrot-ar-drone Tracking-objects-...
1
vote
2answers
51 views

Finding the PID values for a vehicle control system

I'm trying to design a PID system for the longitudinal control of an autonomous vehicle. I figured out about most of it but I'm trying to figure out the Kp, Ki and Kd values. This is an illustration ...
0
votes
1answer
74 views

Improving PID gain constants

I have started building and programming my own quadcopter. I used stm32 f103 and right now I'm testing PID controller. The issue is getting right gain constants. I have build a swing and attached ...