0
$\begingroup$

I am programming an EPSON SCARA robot using RC+ 7.4.8. Any error in compiling the program shows in red in the bottom status bar with the error message, program and line number.

This would be wonderful if the program files had line numbers. I have found no mention of this anywhere on the internet or within EPSON's manual etc.

Does anyone know if it is possible to get line numbers in program files on RC+?

Improve this question
$\endgroup$

1 Answer 1

Reset to default
1
$\begingroup$

I tried looking around online and found a manual for RC+ 4.x that mentioned a "renumber" and "strip line number" command, but the manual for the 7.x version makes no mention of the same, so I downloaded a trial version of the software, looking for those buttons.

I didn't find any way to turn on line numbers in the file, but I did see that it's indicated on the bottom-right corner of the screen. Hope this helps!

Epson RC+ line numbers

Improve this answer
$\endgroup$
2
  • 1
    $\begingroup$ Thanks so much, I hadn't noticed that! $\endgroup$
    – E.Aigle
    Jul 30, 2021 at 6:07
  • $\begingroup$ @E.Aigle Happy to help! :D $\endgroup$
    – Chuck ♦
    Jul 30, 2021 at 13:54

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.