I bought a new Roboduino atmega 328 board. Basically Roboduino is a modded version of Arduino UNO made by robokits.co.in. The problem is
On Windows Plaform: When I tried to upload a simple Blink program that's listed in the examples of Arduino IDE 1.0.4, I got error that avrdude: stk500_getsync(): not in sync: resp=0x00
I chose the correct COM port after verifying it with the Device manager. I installed the Prolific Drivers for the board. I selected the board as Arduino UNO in Arduino IDE.
The complete verbose for the upload is as follow:
D:\Softwares\Installed Files\arduino-1.0.4\hardware/tools/avr/bin/avrdude -CD:\Softwares\Installed Files\arduino-1.0.4\hardware/tools/avr/etc/avrdude.conf -v -v -v -v -patmega328p -carduino -P\\.\COM10 -b115200 -D -Uflash:w:C:\Users\ANKITS~1\AppData\Local\Temp\build5865304215250534760.tmp\Blink.cpp.hex:i avrdude: Version 5.11, compiled on Sep 2 2011 at 19:38:36 Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/ Copyright (c) 2007-2009 Joerg Wunsch System wide configuration file is "D:\Softwares\Installed Files\arduino-1.0.4\hardware/tools/avr/etc/avrdude.conf" Using Port : \\.\COM10 Using Programmer : arduino Overriding Baud Rate : 115200 avrdude: Send: 0   avrdude: Send: 0   avrdude: Send: 0   avrdude: Recv: avrdude: stk500_getsync(): not in sync: resp=0x00 avrdude done. Thank you.
When I plug in the board the power LED is on. The 13 pin LED blinks once. When the IDE shows uploading the 13 pin LED blinks 3-4 times and then the error appears on the screen. In between also sometimes it blinks randomly for 5-6 times. I also tried other example programs but the same follows. I'm using 32 bit Windows 7 Ultimate and the baud rate is set to 9600.
On Ubuntu 13.04:
I downloaded the IDE from Software Center. I was added to the dialouts group on the first run. After connecting the board to my pc I ran two commands
lsusb which returned following output:
Bus 004 Device 003: ID 067b:2303 Prolific Technology, Inc. PL2303 Serial Port Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
dmesg. After this when I tried to upload the same program of blink, it gave me following error:avrdude: stk500_recv(): programmer is not responding. I'm using 64 bit ubuntu 13.04 and selected Arduino UNO as the board.
Thank you for reading this long. Please provide me suggestions for the problem.